Featured Questions

Where can I buy beer on tap for my draught beer cooler?

Beer Dispensing System with built-in compressor – how does it work?

Does the dish need to be cooled or can it be room temperature?

Installation videos for the machines in the Pygmy and Contact Series

I have problems with foam when serving draft beer, how do I fix it?

Faq Sections

Questions regarding serving of draft beer

What equipment do I need to serve draught beer?

Does the dish need to be cooled or can it be room temperature?

How do I know what serving pressure I should have?

Questions regarding air-cooled beer dispensing systems

Beer Dispensing System with built-in compressor – how does it work?

Can I use draft beer coolers from Pygmy and Kontakt series outdoors, for example, in my outdoor kitchen?

If I buy a dish through Systembolaget, what do I need to serve chilled draught beer at home?

Is it capable of connecting an external beer tower to an air-cooled machine in the Kontaktor Pygmy series?

Installation videos for the machines in the Pygmy and Contact Series

Questions regarding serving of carbonated water

Can the carbonic acid corrode the teeth?

Is it better to have still water or tap water compared to carbonated water?

Should children drink carbonated water?

The carbonation level is low, what can I do to adjust it?

When you experience low carbonation level on the carbonated water it is recommended to investigate the the following points:

To have a good sparkling water, You must have cold water (set the thermostat correctly);
Be sure that the Co2 cylinder is not empty or almost empty;
Check the water and Co2 pressure; The water pressure should be:

For Blupura it is between 2-3,5 bar
For Lindr it is between 2-3 bar
Set the CO2 regulator to the recommended value of the machines manual.

For Blupura it is between 3,5-4 bar
For Lindr it is between 4-4,5 bar

The incoming water pressure should at all times be approx. 1 bar below the set CO2 gas pressure. Recommended to be 1 -1,5 bar of difference;
It’s possible to adjust the outlet sparkling flow rate through the FLOW CONTROL. (Turning clockwise, close and reduce the flow Turning counter clockwise, open and increase the flow) I suggest to set the flow control for dispense 0,5 Lt of sparkling water in (around)15seconds; (Blupura only)
Remove any excess air in the circuit by pulling the ring on the safety valve located inside the machine.

Below you will find a video about recommendations for optimal carbonation conditions:
http://www.blupura.com/video-qrcode.asp?id=7

After checking all of the points above we recommend to the following procedure to start the machine back up:

Close the Co2 cylinder;
Remove the air in the circuit by pulling the ring on the remote safety valve until water come out
Push the button or pull the handel to dispense sparkling water with the Co2 cylinder closed. When the water starts to come out, start to open (slowly) the Co2 cylinder to the preferred pressure while still holding down the fizzy button / keeping the tap handle open.

For which applications /use areas can fluidfitproducts be used?

What is the working pressure and temperature of couplings and hoses?

What is the technical specification for couplings and hoses?